Type : SDW-S     SPLIT
Drive through car wash
  
 Wash in 90 seconds!
Shampoo wash and wax in 90 seconds! The fastest wash program is provided to meet the need of speed wash for busy market.
A ordinary speed wash program is also available for better wash quality. Which program to serve is depend on the circumstances.
  
[The multiple sensor system]

The figure of a vehicle to be washed is precisely scanned by the multiple sensor system. The movement of all the brushes and the blower nozzle is controlled by the computer according to the information from this multiple sensor system for better wash quality and safer operation.
To improve the efficiency of blower, a retractable side blower nozzle is employed. By adopting this method, a wide range of vehicle can be dried better than those with fixed side blower nozzle.
The top blower nozzle follows the shape of a vehicle safely according to the information given form the multiple sensor system and maximize the effect of drying.
The top brsu is controlled by the sensitive servo motor and the information from the multiple sensor system so that it could cover as much part of a vehicle without leaving unwashed.
The rocker brush washes the lower side edge of a vehicle where hard sticking dirt is quite usual and can not be washed by the side brush.
 Foam brush(Standard)  Cloth brush(Option)  Pliant brush(Option)
This foam brush is soft but tough and cut with sharp edge so that the edge can scrape off dirt from the painted car body. The tip of each brush fragment is cut in two and cover even narrow space of a vehicle. The volume of tthe brush is also up about 20% for better wash quality. This soft cloth brush is first introduced by us in 1994. Since then this brush has been widely accepted and supported by many users of our car wash. The most recent soft cloth brush is far better improved in wash quality, low noise and durability. This pliant brush is very soft and thin but very elastic at the same time. This very traditional filament type of brush is still the best in wash quality and to cover as much part of a vehicle body as possible. The volume of brushes has also been increased for better wash quality.
  (Jump to 「Aladin Cloth」 page)
Safety system
For safe operation, various safety check system is provided.
1、Hight detection gate (option) 4、Guiding pipe  7、Voice guiding system(option) 10、Tire detection sensor 13、Safe distance measure
2、Entrance control gate 5、Guidiing mirror 8、Rail step(Option) 11、Exit sensor 14、Navigation board
3、Car width safety switch 6、Guiding message board 9、Exit arear sensor 12、Side safety switch 15、Outside chemical supply (Option)
 FK-2 polymer coating (Standard feature)  (Jump to 「FK-2」 page)
     
FK-2 polymer coating system Ordinary wax can not protect car body from acid rain and ultraviolet sun ray. FK-2 polymer coatiing can protect car body from acid rain and ultraviolet sun ray.

 Option  Options available for SPLIT
「UNDER CHASSIS WASH SYSTEM」 (Independently operated)
This under chassis wash system is independently operated from car wash machine. This system is placed at the entrance of the car wash and spray high pressed water from 6 nozzles against under body of a vehicle.
「FOOT SHINE」 (Installed and operated within car wash)

This spray unit is attached to the frame of the car wash and operated together with the process of car wash.。
「ALADIN JET」 

This high pressure spray unit is attached at the ceiling of the car wash and sprays high pressued water to the upper deck of a vehicle.
「FOAM SPRAY UNIT」

This spray unit makes creamy white foam and sprays it on vehicle body. This foam apeals to the users of car wash.
「AQUA DRY SYSTEM」

This is a unique drying system. The water drops remain on a car body after car wash is washed down by the certain volume of water flow. This system is particularly welcomed at the place where the claim against noise is the problem.

   本体寸法
Jump to 「General view」 for installation.
Samle drawing for your image of the insrallation site.

 1 Insutallation space required  4,600mm(W) x 18,000mm(L) x 3,700mm(H)
 2 External measure  3,750mm(W) x 4,155mm(L) x 3,150mm(H)
 3 Max, vehicle size  2,400mm(W) x 2,300mm(H) x 5,300mm(L)
 4 Powerl requirement  12.88Kw (Car wash and water pump only, no option)
 5 Type & number of brushes  Foam brush, 5 brushes, (+ 2 wheel brushes as option )
 6 Operation speed  Inverter controlled, 16 speed
 1) WASH 2'12"。 2) WAX 2'12"。 3)FK-2 3'20"。
 7 Wash program  1) WASH 2) WAX 3) FK-2 coating
 8 Operation method  Easy touch button operation
 9 Drying capacity  3.65Kw x 2 units
10 Water consumption  1) WASH 72L。 2) WAX 72L。 3) FK-2 coating 130L。
11 Chemical  1) Detergent 2) Wax 3) FK-2 polymer coating
Specification are subject to be modified without notice.
Some of the pictures are for Japanese use only and may differ from the export model.
Some pictures include option(s).